Hey Naomi, Jody and all,



There is another way to use MMS, I just wrote to Jenny about this, transdermal... Yes, there is a 

24 hour cancer cure being talked about, I took the recipe from it and will post it below... Keep 

mind, the number of drops will have to be adjusted to what you are currently using, that the 

activator is a little less then orally and using DMSO and MSM are also used... Also, this is a

"one" dose recipe, meaning if you take MMS, 4 drops 3 X daily, you would make your mixture in 

three different doses and take it two hours apart. 



Transdermal should make the MMS more effective and should also eliminate most of the side effects,

such as stomach issues... I think this may be a winner for us Lymies...



Take care,



Jim









Transdermal application of MMS







I just came across this MMS transdermal protocol, it is designed for cancer, but it should be okay for Lyme also.... I know that taking medicines transdermally has benefits, usually more of the medicine is absorbed by the body and less side effects.... You will notice in the recipe below, the normal MMS recipe does not apply.... It actually takes a bit less of the activator, plus DMSO ) and MSM to complete the recipe... This is a single dose recipe and should be repeated throughout the day until the desired amount of drops of MMS have been taken... Keep in mind, the number of drops of MMS below should be adjusted to what you are now taking... Below is an example only.



This is an interesting option to the oral MMS.....







Taking Chlorine Dixoide: Oral or Transdermal?



As mentioned above, Vitamin C, other antioxidants and immune builders, should not be taken during the same time periods as MMS/Chlorine Dioxide. This is good advice.



However, most websites recommend chlorine dioxide be taken orally. When taken orally, the treatment can cause diarrhea, nausea, vomiting, etc. The side-effects are so severe it can take many weeks for a patient to build up to a therapeutic dose. These side-effects only happen if you take this treatment orally. It is the stomach which is causing these side-effects. If you take this treatment transdermally, meaning through the skin; the stomach, and its side-effects, can be totally avoided.



Due to the volume of chlorine dioxide which will be taken in a short amount of time, taking chlorine dioxide orally is absolutely not an option for this treatment.



In addition, since the DMSO is so very critical to this treatment, the DMSO will also cause some stomach upset if taken orally. Thus, there is a second reason to take the treatment transdermally.



But the most important advantage of taking it transdermally is that with transdermal applications, higher doses can be taken (actually small doses are taken several times), and the high daily doses can be achieved much more quickly.



It is rare when more than 30 drops of chlorine dioxide are taken in a day. In this protocol, 130 drops, depending on the weight of the patient, are taken. The drops are spread out evenly over 12 hours (it is critical to spread out the drops). Thus, this is a different kind of treatment.



How to Make "ONE DOSE" of Chlorine Dioxide and DMSO



How many times you take the dose of chlorine dioxide and DMSO will be discussed later. But first, we need to understand how to make "One Dose."



READ THIS SECTION SEVERAL TIMES to make sure you aren't missing anything. Especially read it AFTER making one or two doses!! You would also be smart to have a second person look at the instructions to make sure you both agree on how to make "One Dose."



Step 1: Measuring the MMS



Using the lid on the bottle of MMS, put exactly 10 drops of MMS in a small bowl. This should equal 1/8 of a TEAspoon.



If you weigh between 110 pounds and 130 pounds, use 8 drops instead of 10 drops. IF you weigh 110 pounds or less, use 6 drops instead of 10 drops.



All the instructions below this section are NOT based on weight.



Step 3: Measuring the Volume of the Activator



The "activator" will either be citric acid or lemon juice or lime juice. Each will now be discussed.



Making the Citric Acid

If you are using 10% citric acid as the activator, make sure you dissolve it in water before using it. Here is the formula for what to put in the blue bottle:

1) Put 2 TEAspoons of the citric acid powder in the blue bottle,

2) ADD 3 ounces (i.e. 6 TABLEspoons) of water to the blue bottle (preferrably distilled water or reverse osmosis water).



This will almost fill the blue bottle. This formula has the correct 10% citric acid mixture. Use doses for the activator using the blue bottle.



Lemon Juice or Lime Juice

If you use lemon juice or lime juice as the activator, make sure you filter out all particles using a common kitchen strainer.



The Volume of the Activator

Regardless of your weight, use 5/8 of a TEAspoon of the "activator" (e.g. 10% citric acid) to the MMS.



At this point you should ADD the correct volume of the activator (citric acid, lemon juice or lime juice) to the MMS you already put in the small bowl.



Step 4: Your FIRST Wait of 3 Minutes



AFTER MIXING the MMS (i.e. sodium chlorite) with the activator, stir the mixture, then let it sit for 3 minutes, stirring the mixture every 30 seconds. This three minute wait creates the chlorine dioxide.



Step 5: Measuring the DMSO



AFTER the 3 minutes needed to make chlorine dioxide, add the liquid DMSO to the mixture.



In the same small bowl add 3/4 of a TEAspoon of DMSO. In other words, this is added to the chlorine dioxide you made above regardless of your weight.



Step 6: Your SECOND Wait of 3 Minutes



After ADDING the DMSO to the chlorine dioxide you need to mix the mixture, then wait an additional 3 minutes, stirring the mixture every 30 seconds.



This is the SECOND TIME you have waited 3 minutes. This time you are waiting for the DMSO to bind to the chlorine dioxide.



After this second wait of 3 minutes you have a mixture which is defined to be "One Dose" of Chlorine Dioxide / DMSO.





The steps above can be summarized thusly:



1) Put 10 drops (or 8 drops or 6 drops) of MMS in a small bowl,

2) Add 5/8th of a TEAspoon of the "activator" (citric acid, lemon juice or lime juice),

3) WAIT 3 minutes (stir at first and every 30 seconds) to make the chlorine dioxide,

4) Add 3/4 of a TEAspoon of DMSO,

5) WAIT an additional 3 minutes (stir at first and every 30 seconds) for the DMSO to bind to the chlorine dioxide.



You Have Now Made "One Dose"!!



The mixture you made above contains 10 drops (or 8 drops or 6 drops) of MMS, plus an activator plus DMSO. The entire mixture of MMS, activator and DMSO is called "One Dose." By definition, if you take "10 or 8 or 6 drops" of chlorine dioxide, you are taking "One Dose," meaning the entire mixture above.



Let me repeat that a different way. When it says to take "10 drops (or 8 drops or 6 drops) of chlorine dioxide" it is NOT talking about 10 drops (or 8 drops or 6 drops) of the mixture, it is talking about the ENTIRE mixture!!



Thus, you will never measure drops of the mixture. You will always take the entire mixture because the entire mixture is called "One Dose."



Step 7: Putting the Mixture on the Skin (Transdermal)



When the second three minute wait is completed, you can rub the entire mixture onto your skin. Spead the mixture so that it is thin on your skin. This way it will penetrate faster and will create less of a skin rash.



If is very important to rotate where you put the mixture on the skin. During the "prep" day you will take "One Dose" 4 times, where each dose is separated by 1 hour. The first time you may want to put it on your arms. The second time you may want to rub it on your leg thighs. The third time you may want to rub it on your leg calfs. The next time you use it you will rotate back to your arms. And so on. The person's back can also be used.



By rotating where you put the mixture your skin has 3 hours to completely recover from the DMSO pulling the chlorine dioxide through the skin.



You also have another way to protect your skin. Ten minutes after putting the "One Dose" on the appropriate place on your body (if you can wait that long), you can put MSM Water on that location of the skin if there is any rash developing.



Thus, you have two different ways to protect your skin during the treatment.



It should be mentioned that latex gloves, rubber gloves or any other kind of gloves should NOT be used to spread any mixture containing DMSO. The DMSO can pull the materials in these gloves through the skin. Use bare hands.