It occurred to me to wonder whether following the sciatic nerve along
its course with LED lights or laser would be preferable to pressing
along it with reflexology, so I googled "Sciatica LED lights". Looks as
if this idea is already out there. You have LEDs, don't you? Should be
a painless treatment, at least.
Milk carton in 6 feet of length is the same incline as Ken is using so it takes a lot more than an inclined bed to get there as you have to have gravity...
It occurred to me to wonder whether following the sciatic nerve along its course with LED lights or laser would be preferable to pressing along it with...
I applied my red and infrared LED combo unit along the underside of my painful leg and lower back for a few minutes with no relief. Maybe I should have done...
Hi Bil, If you wish to email me off line (direct), and let me know where the pain site is/pain pattern etc plus what equipment you have on hand, and I’ll...
Kerry Tume
tume@...
Jun 2, 2011 11:37 am
Magnets also are being recommended. You likely have some already? Peter Kulish's site is BiomagScience.net <http://BiomagScience.net> Group:...
Thanks Rowena, I placed a very powerful 4" x 6" x 1" (~96mm x 144mm x 24mm) ceramic magnet under my lower back all night while asleep for 2 nights No...
Hi Bil, Sorry to hear about your sciatic pain, I treat this many times in my clinics, I very often find that the thoracic area is locked up, which the...
Hi Bil, try getting oxygen into you...via oxygen generator and cannula in the nose to breathe directly into the body. This worked for my husband several years...
Sounds great. My oxygen tank is so old I'm not sure it can be certified an filled (due to some rust form age). Of course I have to drive 90 miles to get the...
Thanks David, Since I am too far from any acupuncturist can I apply red and IR LEDs instead? The pain is much less now and same in bed or not. Those exercises...
Hi Bil Sorry to hear about your Sciatica pain trouble.. I have found the Magnetic Pulser to be very effective in reducing the swelling and thus fixing the ...
I have used magnets for pain relief for almost 30 years. Flexible refrigerator magnets will do the job quite nicely in many cases. The 2 most important...
Thanks Alvin, Since I have an EMEM (not a Rife/Bare) I used the complete set in Frex for Sciatica, which includes the freqs you suggested (in direct contact...
Hi Bil You should be able to stop the pain in one application but you will have to do it a number of times.after that to reduce the swelling .With sciatica...
Huge (4" x 6" x 1" ceramic magnet under my entire lower back (under a pillow for comfort). All night, and no help at all (of course North side up, as checked...
Can you locate a scenar therapist? They can reset the whole nervous system. Esther N. Shelley MBE, RHA, CBS, CNHP, D.(Hon)Ac., CAHP Holistic Allergist, Pain...
Hi Bil, Have you done the muscle frequencies from the NCFL? The ones for low back and buttocks and legs and feet? I find these help tremendously. Do you feel...
Hi again Bil, I am currently sitting in my chair wearing a loop of copper wire that we call a Lakhovsky coil. It causes a slow healing in a few minutes for my ...
If I only knew exactly where to place the red/IR LED unit. Under the lower back and running it up and down my entire bad leg had no effect Bil -----Original...
My first go-to for fast relief is topical application of DMSO. It's usually instantaneous. Chuck My first job was working in an Orange Juice factory, but I got...
Thanks Chuck, I applied 99% DMSO many times since the start of this sciatica and it hasn't helped much. Still constant pain throughout my left leg. Bil...
Thanks Alvin, I do have the magpulser (with a 4 turn 6" coil) under my lower back for several hours now. I'll try the 727Hz with the tube and ground plate in...
HI Bil Yes pulsing the area directly will stop the pain in a short time.. Use the 727 in the full contact mode.for the EMEM .I am still doing lots of tvs ...
Hi Alvin, I'll give the 727 another try. Yeah the new flat panel TVs are not as heavy (per screen size), but since most people buy huge ones I'm still gonna...
Hi Bil, Don't forget to get your bed inclined, minimum of 6 inches, better at 8 inches. Saw an old client who labors at asphalt business (making roads). Nearly...
Ken, Can you explain how the incline should look....head or or feet inclined? Does the whole bed get raised or do you have to buy a hospital bed that inclines...
Ken, I do not contribute often on this sight - I am a reader/learner. I felt compelled to share our IBT experience. 14 years ago my husband suffered an ...
Please allow me to but in here, Lisa. No one else answered your question. I have been on an inclined bed for a few years, and it has cured my sleep apnea....
Offline 
Send Email