Poloroid one step, type camera...

Byron


--- In biophoton@yahoogroups.com, Leslie Brennan <les90000@y...> wrote:
>
> Hi, I subscribe to this group but have never posted before. I'm
curious? When you
> speak about polaroid photos do you mean a polaroid 35 mm camera or
simply the type of camera that just prints out a photo as aoon as you
take a picture? Can you recommend a model?
> Thanks,
> Leslie
>
> tymetoplay2001 <tymetoplay2001@y...> wrote:
> My experience (practitioner of 30 yrs), has shown me that the
poloroid
> photos work much better than digital...have found digitals give false
> readings when doing testing and are flat energetically.
>
> Jeff did some transmissions via his machine and mine that produced no
> results for me,a few years ago...digital photo he produced was the
> witness...not saying it was because of the digital...just sharing
> outcome using digital...
>
> I recommend poloroids over digitals...
>
> Byron
>
>
>
>
> --- In biophoton@yahoogroups.com, "QB" <quantumbalancing@y...> wrote:
> >
> > Robert,
> >
> > Dr. Jeff Sutherland believes that digital photographs can be very
> > effective when used with the ABPA. He reported this on his website
> > (http://www.frequencyresearch.org/) as shown below:
> >
> > The Advanced Biophoton Analyzer (ABPA) is a device that can be used
> > for many purposes. One of them is to broadcast frequencies on a very
> > low frequency carrier wave that can penetrate the earth and is
> > independent of distance. Years of work on refining the
> > hardware/software setup of this device enables excellent effects at
> > a distance. The frequency effect on a living organism at a remote
> > location is comparable to being in the room with an EMEM plasma
> > device or directly connected to electrodes. Contact Dale Fawcett at
> > (360) 598-6585 to discuss details of how this is possible.
> >
> > The ABPA has some advantages over direct contact with frequency
> > devices as it is able to monitor the energy system of the target and
> > only transmit information that will balance that energy system and
> > bring it into a higher energy state. It is a self-correcting device
> > that works with and enhances the effect of frequency generators
> > attached to it.
> >
> > I am often asked about using the Advanced Biophoton Analyzer (ABPA)
> > with frequency devices and how to connect an F160 or FSCAN. The
> > photo above shows an F160 connected to the ABPA wire which runs
> > under the ABPA input well.
> >
> > The wire that comes with the ABPA has the best impedance match to
> > the device and provides about five times the power output of using
> > common phono jack cable that is terminated correctly with a 50 ohm
> > resistor. Because the APBA cable has a mini-phono jack at the end of
> > it you will need a female mini-phono jack to male phono jack
> > converter from Radio Shack that will allow the ABPA cable to plug
> > into an FSCAN2. Use the power port on the FSCAN2 with the voltage
> > turned all the way up to 16 volts. This provides the maximum
> > magnetic field around the cable. Placing the cable under the input
> > well of the ABPA allows the magnetic field around the cable to
> > extend up into the input well where it is scanned and transmitted.
> >
> > The F160 has a female BNC connector so you must get an additional
> > part from Radio Shack. You need a female phono jack to male BNC
> > connector converter. Turn the voltage all the way up on the F160 as
> > well. This will work for FSCANs with BNC connectors.
> >
> > There are eight switches on the ABPA. For frequency work they should
> > be set as follows:
> >
> > Inherited IDF - Off
> > Chemical Sensitivities - Off
> > Dampening Field - Off
> > Antidote/Clone - Auto
> > Balance/Neutralize - Auto
> > On/Off - On
> > Send/Off - Send
> > Plant/Animal - Auto
> >
> > A final tip that will magnify the output of the ABPA is to take a
> > high resolution photo of the target and print it out on 8.5x11"
> > paper on a high quality printer (1200 dpi or better). Fold the paper
> > into quarters and put it in the photo well of the ABPA.
> >
> > The improvement in performance with these strategies is quite
> > significant. Hooking up the cable properly with increase
> > effectiveness by 5 times. Using a high resolution digital photo
> > instead of a Polaroid photo will give another 5 fold improvement.
> > Taking the picture with the camera on a tripod will double the
> > effective resolution and multiply output by 2. Finally, printing the
> > photo in an 8.5x11" format gives a fourfold gain. You now have a
> > device that works 5x5x2x4=200 times better than previously!
> >
> > The only challenge remaining is finding the right frequencies for
> > your purposes. As Dr. Royal Rife once said, if you have the wrong
> > frequency or set of frequencies you will get no effect. For help in
> > finding the right frequencies for your needs, contact the Frequency
> > Research Foundation.
> >
>
>
>
>
>
>
>
> Please limit messages to subject matter of general interest to all.
Thank you. The Moderators.
>
>
>
> SPONSORED LINKS
> Health and wellness Alternative medicine Health wellness
product Health and wellness program Health promotion and
wellness Business health wellness
>
> ---------------------------------
> YAHOO! GROUPS LINKS
>
>
> Visit your group "biophoton" on the web.
>
> To unsubscribe from this group, send an email to:
> biophoton-unsubscribe@yahoogroups.com
>
> Your use of Yahoo! Groups is subject to the Yahoo! Terms of
Service.
>
>
> ---------------------------------
>
>
>
>
>
>
> ---------------------------------
> Yahoo! for Good - Make a difference this year.
>